Hogue rubber grips are moulded from durable synthetic rubber that is neither spongy nor tacky yet provides a soft recoil absorbing feel without affecting accuracy. This modern rubber requires a completely different moulding process than ordinary neoprene resulting in a much superior grip. The flexibility of our materials and moulding process has allowed us to produce rubber grips with features that out perform all other makes.
Features and Specifications
Original one-piece Monogrip design eliminates side screws and loose shifting panels.
Hogue's famed Orthopedic hand shape with finger grooves and compound palm swells.
Fully relieved for all speedloaders.
Moulded from modern durable rubber which is virtually impervious to all oils and solvents found around firearms.
Cobblestone texture provides an efficient non-slip, non-irritating stippling pattern.
Hogue rubber Monogrips feel soft and resilient in your hand, yet are moulded with a reinforcing insert directly engaging with the gun frame for a rock-solid grip-to-frame fit.
Includes unique snap-on mounting attachment
Total packaged weight: 110g
Fits: S&W K or L Square Butt
- 1. Before starting to work, make sure the firearm is unloaded. Remove the existing grips.
- 2. Place the stirrup over the bottom strap of the handle and rotate it until the hole in each side engages the stock pin.
- 3. When in place, the stirrup is a clamp that provides a screw thread hanging below the handle for securing the Monogrip to the frame. No alternation of the firearm frame is needed. Remove the screw from the stirrup.
- 4. Mate the firearm handle and Monogrip by first placing the stirrup and stock pin into the internal guide grooves using your thumb to spread the grip.
- 5. Monogrip should be guided up behind the trigger guard, then pivoted to cover the frame straps. The grip must mate with the semi-circular loops at the top of the gun handle. Monogrip must be fully seated on the frame before inserting mounting screw.
- 6. Insert the mounting screw through the hole on the bottom of the grip. Insert the screw so it enters the stirrup threads, and using an appropriate screwdriver, tighten the screw until snug, no tighter. Over-tightening does nothing to increase grip tightness and can damage the screw or stirrup.
Model: Hogue 10000
- 7. Your Monogrip is designed to fit an average size firearm frame. However, frame dimensions do vary slightly from firearm to firearm. If necessary your Monogrip can be adjusted by placing small shim(s) of tape on the lower corner of the front strap. Add or subtract tape until grip is flushed with backstrap.